Anritsu MS2830A - :CALCulate:MARKer:PEAK:THReshold:STATe ON|OFF|1|0; :CALCulate:MARKer:PEAK:THReshold:STATe?

2.5 Signal Search
2-175
2
SCPI Device Message Details
:CALCulate:MARKer:PEAK:THReshold:STATe ON|OFF|1|0
Peak Search Threshold Level On/Off
Function
This command sets the threshold On/Off, when searching for the peak
point.
Command
:CALCulate:MARKer:PEAK:THReshold:STATe <switch>
Parameter
<switch>
Threshold when searching for the peak point
0|OFF
Sets the threshold to Off (Default).
1|ON
Sets the threshold to On.
Details
This command is not available during Spurious Emission measurement
and when Displayed Segment Mode is Auto.
Not available during Spectrum Emission Mask measurement.
Example of Use
To set the threshold when searching for the peak point to On.
CALC:MARK:PEAK:THR:STAT ON
:CALCulate:MARKer:PEAK:THReshold:STATe?
Peak Search Threshold Level On/Off Query
Function
This command queries the On/Off state of the threshold when searching
for the peak point.
Query
:CALCulate:MARKer:PEAK:THReshold:STATe?
Response
<switch>
Parameter
<switch>
Threshold when searching for the peak point
0
Sets the threshold to Off.
1
Sets the threshold to On.