Anritsu MS2830A - SWE:EGAT:VIEW:FREQ;SWE:EGAT:VIEW:FREQ?

Chapter
４
Native Device Message Details
4-329
4
Native Device Message Details
SWE:EGAT:VIEW:FREQ/SWE:EGAT:VIEW:FREQ?
Gate View Frequency
Function
This command sets the center frequency for Gate View.
Command
SWE:EGAT:VIEW:FREQ freq
Query
SWE:EGAT:VIEW:FREQ?
Response
freq
Parameter
freq
Center Frequency
[MS269xA]
–100 MHz to 6.05 GHz (MS2690A)
–100 MHz to 13.6 GHz (MS2691A)
–100 MHz to 26.6 GHz (MS2692A)
[MS2830A]
–100 MHz to 3.7 GHz (MS2830A-040)
–100 MHz to 6.1 GHz (MS2830A-041)
–100 MHz to 13.6 GHz (MS2830A-043)
–100 MHz to 26.6 GHz (MS2830A-044)
–100 MHz to 43.1 GHz (MS2830A-045)
[MS2840A]
–100 MHz to 3.7 GHz (MS2840A-040)
–100 MHz to 6.1 GHz (MS2840A-041)
–100 MHz to 26.6 GHz (MS2840A-044)
–100 MHz to 44.6 GHz (MS2840A-046)
Resolution 1 Hz
Suffix code HZ, KHZ, KZ, MHZ, MZ, GHZ, GZ
Hz is used when omitted.
Details
This command is not available when Gate View is set to Off.
Example of Use
To set the center frequency for Gate View.
SWE:EGAT:VIEW:FREQ 123456
SWE:EGAT:VIEW:FREQ?
> 123456