Anritsu MS2830A - :CALCulate:MARKer[1]|2|3|4|5|6|7|8|9|10:X:POSition?

Chapter 2 SCPI Device Message Details
2-110
Related command
This command has the same function as the following commands.
:CALCulate:ACPower:MARKer[1]|2|3|4|5|6|7|8|9|10:X:POSiti
on
:CALCulate:CHPower:MARKer[1]|2|3|4|5|6|7|8|9|10:X:POSiti
on
:CALCulate:OBWidth:MARKer[1]|2|3|4|5|6|7|8|9|10:X:POSiti
on
:CALCulate:BPOWer|:TXPower:MARKer[1]|2|3|4|5|6|7|8|9|10:
X:POSition
:CALCulate:SPURious:MARKer[1]|2|3|4|5|6|7|8|9|10:X:POSit
ion
:CALCulate:MARKer[1]|2|3|4|5|6|7|8|9|10:X:POSition?
Zone Marker Position Query
Function
This command queries the center position of the zone marker.
Query
:CALCulate:MARKer[n]:X:POSition?
Response
<integer>
Parameter
<n>
Marker number
1
Marker 1
2
Marker 2
3
Marker 3
4
Marker 4
5
Marker 5
6
Marker 6
7
Marker 7
8
Marker 8
9
Marker 9
10
Marker 10
When omitted: Marker 1
<integer>
Number of display points from the left edge of
the screen
Range 0 to 10, 20, 40, 50, 100, 200, 250, 400, 500, 1000,
2000, 5000, 10000, 30000 (MS269xA Only)