Anritsu MS2830A - [:SENSe]:SPURious:TDOMain[:RANGe][:LIST]:BANDwidth:VIDeo <bandwidth_1>|OFF,<bandwidth_2>|OFF,<bandwidth_3>|OFF,<bandwidth_4>|OFF,<bandwidth_5>|OFF,<bandwidth_6>|OFF,<bandwidth_7>|OFF,<bandwidth_8>|OFF,<bandwidth_9>|OFF,<bandwidth_10>|OFF,<bandwidth_1...

2.14 Spurious Emission Measurement Function
2-789
2
SCPI Device Message Details
[:SENSe]:SPURious:TDOMain[:RANGe][:LIST]:BANDwidth:VIDeo
<bandwidth_1>|OFF,<bandwidth_2>|OFF,<bandwidth_3>|OFF,<bandwidth_4
>|OFF,<bandwidth_5>|OFF,<bandwidth_6>|OFF,<bandwidth_7>|OFF,<bandw
idth_8>|OFF,<bandwidth_9>|OFF,<bandwidth_10>|OFF,<bandwidth_11>|OFF
,<bandwidth_12>|OFF,<bandwidth_13>|OFF,<bandwidth_14>|OFF,<bandwidt
h_15>|OFF,<bandwidth_16>|OFF,<bandwidth_17>|OFF,<bandwidth_18>|OFF
,<bandwidth_19>|OFF,<bandwidth_20>|OFF
Spurious Emission Time Domain VBW
Function
This command sets VBW in Time Domain Setup.
Command
[:SENSe]:SPURious:TDOMain[:RANGe][:LIST]:BANDwidth:VIDeo
<bandwidth_n>|OFF
Parameter
<bandwidth_n>
Video bandwidth of Segment n (VBW)
Range/Resolution 1 Hz to 10 MHz (1-3 sequence), 5 kHz
Suffix Code HZ,KHZ,KZ,MHZ,MZ,GHZ,GZ
Hz is used when omitted.
OFF
VBW is set to Off.
Details
The setting range of this function is limited depending on the setting of
RBW. For details, refer to
MS2690A/MS2691A/MS2692A Signal Analyzer
Operation Manual (Spectrum Analyzer Function Operation)
or
MS2830A/MS2840A Signal Analyzer Operation Manual (Spectrum
Analyzer Function Operation)
.
Example of Use
To set VBW in Time Domain Setup.
SPUR:TDOM:BAND:VID
3KHZ,3KHZ,1MHZ,1MHZ,1MHZ,1MHZ,1MHZ,1MHZ,1MHZ,1MHZ,1MHZ,1
MHZ,1MHZ,1MHZ,1MHZ,1MHZ,1MHZ,1MHZ,1MHZ,1MHZ