Anritsu MS2830A - :CALCulate:DETector[:FUNCtion] NORMal|POSitive|SAMPle|NEGative|RMS|QPEak|CAVerage|CRMS

2.7 Sweep/Trigger/Gate
2-269
2
SCPI Device Message Details
Example of Use
To query the detection mode.
DET?
> POS
Related command
This command has the same function as the following commands.
[:SENSe]:ACPower:DETector[:FUNCtion]?
[:SENSe]:CHPower:DETector[:FUNCtion]?
[:SENSe]:OBWidth:DETector[:FUNCtion]?
:CALCulate:DETector[:FUNCtion]?
:CALCulate:ACPower:DETector[:FUNCtion]?
:CALCulate:CHPower:DETector[:FUNCtion]?
:CALCulate:OBWidth:DETector[:FUNCtion]?
:CALCulate:DETector[:FUNCtion]
NORMal|POSitive|SAMPle|NEGative|RMS|QPEak|CAVerage|CRMS
Detection Mode
Function
This command selects the detection mode of the waveform pattern.
When Couple Time/Freq. Domain is set to Off, each parameter is
specified in accordance with the already-specified frequency axis or time
axis measurement. Refer to
[:SENSe]:DETector[:FUNCtion].
Related command
This command has the same function as the following commands.
[:SENSe]:DETector[:FUNCtion]
[:SENSe]:ACPower:DETector[:FUNCtion]
[:SENSe]:CHPower:DETector[:FUNCtion]
[:SENSe]:OBWidth:DETector[:FUNCtion]
:CALCulate:ACPower:DETector[:FUNCtion]
:CALCulate:CHPower:DETector[:FUNCtion]
:CALCulate:OBWidth:DETector[:FUNCtion]