Anritsu MS2830A - [:SENSe]:RADio:STANdard:LOAD <function>[,<pattern>]

Chapter 2 SCPI Device Message Details
2-324
[:SENSe]:RADio:STANdard:LOAD <function>[,<pattern>]
Load Standard Parameter
Function
This command selects the Measure function parameter. Selectable
parameters vary depending on the setting for Standard.
Command
[:SENSe]:RADio:STANdard:LOAD <function>[,<pattern>]
Parameter
<function>
Measure function
ADJ
ACP measurement
BRSTAVGPWR
Burst Average Power measurement
OBW
OBW measurement
CHPWR
Channel Power measurement
SEM
Spectrum Emission Mask measurement
SPUR
Spurious Emission measurement
When Standard is set to W-CDMA Uplink (ACP measurement)
<pattern>
Parameter to be set
UPLINK
3GPP W-CDMA Uplink, ACP measurement
When omitted: 3GPP W-CDMA Uplink, ACP measurement
When Standard is set to W-CDMA Uplink (Burst Average Power
measurement)
<pattern>
Parameter to be set
MEAN
3GPP W-CDMA Uplink, Mean Power
measurement
When omitted: 3GPP W-CDMA Uplink, Mean Power
measurement
When Standard is set to W-CDMA Uplink (OBW measurement)
<pattern>
Parameter to be set
UPLINK
3GPP W-CDMA Uplink
When omitted: 3GPP W-CDMA Uplink