Anritsu MS2830A - [:SENSe]:SPURious[:RANGe][:LIST]:FREQuency:STARt <freq_1>,<freq_2>,<freq_3>,<freq_4>,<freq_5>,<freq_6>,<freq_7>,<freq_8>,<freq_9>,<freq_10>,<freq_11>,<freq_12>,<freq_13>,<freq_14>,<freq_15>,<freq_16>,<freq_17>,<freq_18>,<freq_19>,<freq_20>

Chapter 2 SCPI Device Message Detail
2-734
[:SENSe]:SPURious[:RANGe][:LIST]:FREQuency:STARt
<freq_1>,<freq_2>,<freq_3>,<freq_4>,<freq_5>,<freq_6>,<freq_7>,<freq_8>,
<freq_9>,<freq_10>,<freq_11>,<freq_12>,<freq_13>,<freq_14>,<freq_15>,<fr
eq_16>,<freq_17>,<freq_18>,<freq_19>,<freq_20>
Spurious Emission Start Frequency
Function
This command sets the start frequency of each segment.
Command
[:SENSe]:SPURious[:RANGe][:LIST]:FREQuency:STARt <freq_n>
Parameter
<freq_n>
Start frequency of segment n
Range
[MS269xA]
–
100
MHz to 6.0499997 GHz (MS2690A)
–
100
MHz to 13.5999997 GHz (MS2691A)
–
100
MHz to 26.5999997 GHz(MS2692A)
[MS2830A]
–
100
MHz to 3.6999997 GHz (Option 040)
–
100
MHz to 6.0999997 GHz (Option 041)
–
100
MHz to 13.5999997 GHz (Option 043)
–100 MHz to 26.5999997 GHz (Option 044)
–100 MHz to 43.0999997 GHz (Option 045)
[MS2840A]
–
100
MHz to 3.6999997 GHz (Option 040)
–
100
MHz to 6.0999997 GHz (Option 041)
–100 MHz to 26.9999997 GHz (Option 044)
–100 MHz to 44.9999997 GHz (Option 046)
Resolution 1 Hz
Suffix Code HZ,KHZ,KZ,MHZ,MZ,GHZ,GZ
Hz is used when omitted.
Default
[MS269xA]
Segment 1 9 kHz
Segment 2 150 kHz
Segment 3 30 MHz
Segment 4 1 GHz
Segment 5 2 GHz
Segment 6 3 GHz
Segment 7 4 GHz
Segment 8 5 GHz
Segment 9 6 GHz