Anritsu MS2830A - [:SENSe]:POWer[:RF]:ATTenuation:AUTO ON|OFF|1|0

2.2 Level
2-61
2
SCPI Device Message Details
[:SENSe]:POWer[:RF]:ATTenuation:AUTO ON|OFF|1|0
RF Attenuator Auto/Manual
Function
This command enables/disables the automatic attenuation setting
function.
Command
[:SENSe]:POWer[:RF]:ATTenuation:AUTO <switch>
Parameter
<switch>
Automatic attenuation setting function On/Off
state
0|OFF
Disables the automatic attenuation setting
function.
1|ON
Enables the automatic attenuation setting
function (Default value).
Details
This command is not available in the following situations:
•
When Spurious Emission is On AND when Gate View is Off.
Example of Use
To enable the automatic attenuation setting function.
POW:ATT:AUTO ON