Chapter 2 SCPI Device Message Details
2-448
[:SENSe]:BPOWer|:TXPower:CORRection:NOISe[:AUTO] ON|OFF|1|0
Noise Cancel
Function
This command enables/disables the noise canceling function.
Command
[:SENSe]:BPOWer|:TXPower:CORRection:NOISe[:AUTO] <switch>
Parameter
<switch>
Noise canceling function On/Off
ON|1
Enables the noise canceling function.
OFF|0
Disables the noise canceling function.
Details
This command is fixed to Off and cannot be set in the following cases:
•
Burst Average Power is Off.
•
Standard is Off.
•
Standard Parameter which can execute the noise canceling function is
not set in Load Standard Parameter.
•
Any of Span, RBW, Detection, Sweep Time, VBW (when Detection is
not set to RMS), and VBW Mode (when VBW is not set to Off and when
Detection is not set to RMS) has been changed from Standard
Parameter.
•
Scale Mode is Linear.
Example of Use
To disable the noise canceling function.
BPOW:CORR:NOIS OFF
Related command
This command has the same function as the following command.
:CALCulate:BPOWer|:TXPower:CORRection:NOISe[:AUTO]
To Next Page
Loading...
