Anritsu MS2830A - TSLINAVG; TSMAXHOLD

Chapter
４
Native Device Message Details
4-352
TSLINAVG
Linear Average Sweep
Function
This command sets storage mode to Linear Average and starts sweep.
Command
TSLINAVG
Details
Starting sweep with this function makes the following command wait
without being processed until sweep is finished.
Example of Use
To set the storage mode to Linear Average and start sweep.
TSLINAVG
TSMAXHOLD
Max Hold Sweep
Function
This command sets the storage mode to Max Hold and start sweep.
Command
TSMAXHOLD
Details
Starting sweep with this function makes the following command wait
without being processed until sweep is finished.
Example of Use
To set the storage mode to Max Hold and start sweep.
TSMAXHOLD