Anritsu MS2830A - :TRIGger[:SEQuence]:FRAMe:SYNC EXTernal[1]|IMMediate|Off|WIF|RFBurst

2.7 Sweep/Trigger/Gate
2-289
2
SCPI Device Message Details
:TRIGger[:SEQuence]:FRAMe:SYNC
EXTernal[1]|IMMediate|Off|WIF|RFBurst
Frame Sync Source
Function
This command selects the synchronized signal source for frame trigger
start.
Command
:TRIGger[:SEQuence]:FRAMe:SYNC <sync>
Parameter
<sync>
Synchronized signal source
EXTernal[1]
External input
IMMediate|Off
Free run
WIF|RFBurst
Wideband IF detection (Wide IF Video)
Details
This command is not available for MS269x Series.
This setting is shared by the trigger signal and gate signal. The same
value is also used when frame trigger is selected as the gate signal source
for gate sweep.
Example of Use
To set the frame trigger synchronized source to Wide IF Video trigger.
TRIG:FRAM:SYNC WIF