2.7 Sweep/Trigger/Gate
2-281
2
SCPI Device Message Details
:TRIGger[:SEQuence]:VIDeo:SLOPe?
Trigger Slope Query
Function
This command queries the detection mode for the trigger (rise/fall).
Refer to
:TRIGger[:SEQuence]:EXTernal[1]:SLOPe?
Related command
This command has the same function as the following commands.
:TRIGger[:SEQuence]:EXTernal[1]:SLOPe?
:TRIGger[:SEQuence]:WIF|:RFBurst:SLOPe?
:TRIGger[:SEQuence]:EXTernal[1]:DELay <time>
Trigger Delay
Function
This command sets the delay from the trigger occurrence point to sweep
start.
Command
:TRIGger[:SEQuence]:EXTernal[1]:DELay <time>
Parameter
<time>
Delay time to start gating
Range –1 to 1 s
Resolution 20 ns
Suffix Code NS, US, MS, S
S is used when omitted.
Default 0 ns
Example of Use
To set the trigger delay time to 20 ms.
TRIG:EXT:DEL 20MS
Related command
This command has the same function as the following commands.
:TRIGger[:SEQuence]:WIF|:RFBurst:DELay
:TRIGger[:SEQuence]:VIDeo:DELay
To Next Page
Loading...
