Anritsu MS2830A - [:SENSe]:SEMask:SWEep[1]:TIME:AUTO ON|OFF|1|0

Chapter 2 SCPI Device Message Details
2-622
[:SENSe]:SEMask:SWEep[1]:TIME:AUTO ON|OFF|1|0
Spectrum Emission Mask Sweep Time Auto/Manual
Function
This command enables/disables the automatic sweep time setting
function when measuring the reference power for Spectrum Emission
Mask measurement.
Command
[:SENSe]:SEMask:SWEep[1]:TIME:AUTO <switch>
Parameter
<switch>
Automatic sweep time setting function On/Off
ON|1
Enables the automatic sweep time setting
function.
OFF|0
Disables the automatic sweep time setting
function.
Details
The setting range of this function is limited depending on the settings of
other parameters. Refer to the
MS2690A/MS2691A/MS2692A Signal
Analyzer Operation Manual (Spectrum Analyzer Function Operation)
” or
MS2830A/MS2840A Signal Analyzer Operation Manual (Spectrum
Analyzer Function Operation)
for details.
Example of Use
To enable the automatic sweep time setting function when measuring the
reference power.
SEM:SWE:TIME:AUTO ON