Anritsu MS2830A - :CALCulate:MARKer[1]|2|3|4|5|6|7|8|9|10:TRACe 1|2|3|4|5|6

2.4 Marker
2-135
2
SCPI Device Message Details
:CALCulate:MARKer[1]|2|3|4|5|6|7|8|9|10:TRACe 1|2|3|4|5|6
Marker Trace
Function
This command selects a trace to operate the marker (marker trace).
Command
:CALCulate:MARKer[n]:TRACe <mode>
Parameter
<n>
Marker number
1
Marker 1
2
Marker 2
3
Marker 3
4
Marker 4
5
Marker 5
6
Marker 6
7
Marker 7
8
Marker 8
9
Marker 9
10
Marker 10
When omitted: All markers
<mode>
Type of trace to be activated
1
Trace A
2
Trace B
3
Trace C
4
Trace D
5
Trace E
6
Trace F
Details
This command is not available in the following cases:
•
During the Spectrum Emission Mask measurement.
•
During the Spurious Emission measurement.
Example of Use
To set trace B of all markers as the marker trace.
CALC:MARK:TRAC 2
Related command
This command has the same function as the following command.
:TRACe:ACTive