Anritsu MS2830A - [:SENSe]:BPOWer|:TXPower:BURSt:STARt?; :CALCulate:BPOWer|:TXPower:BURSt:STARt?

Chapter 2 SCPI Device Message Details
2-452
[:SENSe]:BPOWer|:TXPower:BURSt:STARt?
Burst Average Power Start Time Query
Function
This command queries the start position (time) for Burst Average Power
measurement.
Query
[:SENSe]:BPOWer|:TXPower:BURSt:STARt?
Response
<time>
Parameter
<time>
Start position (time)
Range Within the frequency range of trace display
Resolution Formula for calculating the resolution is:
Sweep Time / (Trace Point – 1)
(Minimum value: 1ns)
Suffix code None. Value is returned in S units.
Example of Use
To query the start position (time) for Burst Average Power measurement.
BPOW:BURS:STAR?
> 0.020000000
Related command
This command has the same function as the following command.
:CALCulate:BPOWer|:TXPower:BURSt:STARt?
:CALCulate:BPOWer|:TXPower:BURSt:STARt?
Burst Average Power Start Time Query
Function
This command queries the start position (time) for Burst Average Power
measurement.
Refer to
[:SENSe]:BPOWer|:TXPower:BURSt:STARt?.
Related command
This command has the same function as the following command.
[:SENSe]:BPOWer|:TXPower:BURSt:STARt?