Anritsu MS2830A - CALC:MARK:MAX:POW

Chapter
４
Native Device Message Details
4-43
4
Native Device Message Details
CALC:MARK:MAX:POW
Power Peak Search
Function
This command moves the active marker to the position where the peak
power of the zone width of the active marker becomes maximum in the
measurement band.
Command
CALC:MARK:MAX:POW n
Parameter
n
Marker No
1
Specifies marker 1
2
Specifies marker 2
3
Specifies marker 3
4
Specifies marker 4
5
Specifies marker 5
6
Specifies marker 6
7
Specifies marker 7
8
Specifies marker 8
9
Specifies marker 9
10
Specifies marker 10
Details
This cannot be executed under the following conditions:
•
In Time Domain
•
When Scale Mode is Linear
•
When active trace is Blank
•
When Spurious Emission measurement is On and Displayed Segment
Mode is Auto
•
When Spectrum Emission Mask measurement is On
Example of Use
To move marker 1 to position where peak power of zone width is
maximum value.
CALC:MARK:MAX:POW 1