Anritsu MS2830A - :STATus:OPERation:PTRansition <integer>

Chapter 2 SCPI Device Message Detail
2-984
:STATus:OPERation:PTRansition <integer>
Operation Status Register Positive Transition
Function
This command sets the transition filter (positive direction change) of the
OPERation status register.
Command
:STATus:OPERation:PTRansition <integer>
Parameter
<integer>
Total byte of transition filter (positive direction
change)
Resolution 1
Range 0 to 65535
Details
This command is available only in the SCPI mode.
Example of Use
To set the transition filter (positive direction change) of the OPERation
status register to 16.
STAT:OPER:PTR 16