Anritsu MS2830A - [:SENSe]:SEMask:OFFSet[1]:LIST:BANDwidth[1]:VIDeo:AUTO <switch_1>[,<switch_2>[,<switch_3>[,<switch_4>[,<switch_5>[,<switch_6>[,<switch_7>[,<switch_8>[,<switch_9>[,<switch_10>[,<switch_11>[,<switch_12>]]]]]]]]]]]

Chapter 2 SCPI Device Message Details
2-612
[:SENSe]:SEMask:OFFSet[1]:LIST:BANDwidth[1]:VIDeo:AUTO
<switch_1>[,<switch_2>[,<switch_3>[,<switch_4>[,<switch_5>[,<switch_6>[,<
switch_7>[,<switch_8>[,<switch_9>[,<switch_10>[,<switch_11>[,<switch_12>]
]]]]]]]]]]
Spectrum Emission Mask Offset Video Bandwidth Auto/Manual
Function
This command enables/disables the automatic video bandwidth (VBW)
setting function for the offset during Spectrum Emission Mask
measurement.
Command
[:SENSe]:SEMask:OFFSet[1]:LIST:BANDwidth[1]:VIDeo:AUTO
<switch_n>
Parameter
<switch_n>
Automatic video bandwidth setting function
On/Off for Offset-n
ON|1
Enables the automatic video bandwidth setting
function.
OFF|0
Disables the automatic video bandwidth setting
function.
Details
The setting range of this function is limited depending on the settings of
RBW. Refer to the
MS2690A/MS2691A/MS2692A Signal Analyzer
Operation Manual (Spectrum Analyzer Function Operation)
or
MS2830A/MS2840A Signal Analyzer Operation Manual (Spectrum
Analyzer Function Operation)
for details.
Example of Use
To enable the automatic video bandwidth setting function for the offset.
SEM:OFFS:LIST:BAND:VID:AUTO
ON,ON,ON,ON,ON,ON,ON,ON,ON,ON,ON,ON