Anritsu MS2830A - SEM:OFFS:LIST:BAND;SEM:OFFS:LIST:BAND?

Chapter
４
Native Device Message Details
4-228
SEM:OFFS:LIST:BAND/SEM:OFFS:LIST:BAND?
Spectrum Emission Mask Offset Resolution Bandwidth
Function
This command sets the resolution bandwidth (RBW) of the offset for
Spectrum Emission Mask measurement.
Command
SEM:OFFS:LIST:BAND
bandwidth_1[,bandwidth_2[,bandwidth_3[,bandwidth_4[,band
width_5[,bandwidth_6[,bandwidth_7[,bandwidth_8[,bandwidt
h_9[,bandwidth_10[,bandwidth_11[,bandwidth_12]]]]]]]]]]]
Query
SEM:OFFS:LIST:BAND?
Response
bandwidth_1,bandwidth_2,bandwidth_3,bandwidth_4,bandwidt
h_5,bandwidth_6,bandwidth_7,bandwidth_8,bandwidth_9,band
width_10,bandwidth_11,bandwidth_12
Returns a value of Hz units, without a suffix code.
Parameter
bandwidth_n
Resolution bandwidth (RBW) of Offset-n
[MS269xA]
Range/Resolution 30 Hz to 3 MHz (1-3 sequence),
50 kHz, 5 MHz, 10 MHz, 20 MHz
[MS2830A], [MS2840A]
Range/Resolution 30 Hz to 3 MHz (1-3 sequence),
500 Hz, 50 kHz, 2 MHz, 5 MHz, 10 MHz, 20
MHz
[Common]
Suffix code HZ,KHZ,KZ,MHZ,MZ,GHZ,GZ
Hz is used when omitted.
Details
For the MS2830A, MS2840A, RBW of 20 MHz and higher can be used
only when MS2830A-005/105/007/009/109, MS2840A-005/105/009/109 is
installed.
The setting range of this function is limited depending on the settings of
other parameters. Refer to
MS2690A/MS2691A/MS2692A Signal
Analyzer Operation Manual (Spectrum Analyzer Function Operation)
or
MS2830A/MS2840A Signal Analyzer Operation Manual (Spectrum
Analyzer Function Operation)
for details.