Anritsu MS2830A - [:SENSe]:SEMask:AVERage[:STATe] ON|OFF|1|0

2.13 Spectrum Emission Mask
2-703
2
SCPI Device Message Details
[:SENSe]:SEMask:AVERage[:STATe] ON|OFF|1|0
Storage Mode
Function
This command sets the storage mode for Trace A.
Command
[:SENSe]:SEMask:AVERage[:STATe] <switch>
Parameter
<switch>
Setting of Storage Mode
ON|1
Sets Storage Mode to Linear Average.
OFF|0
Sets Storage Mode to Off (Default).
Example of Use
To set the storage mode for Trace A to Off.
SEM:AVER OFF
Related command
This command has the same function as the following commands.
:TRACe[1]|2|3|4|5|6:STORage:MODE
[:SENSe]:ACPower:AVERage[:STATe]
[:SENSe]:CHPower:AVERage[:STATe]
[:SENSe]:OBWidth:AVERage[:STATe]
[:SENSe]:BPOWer|:TXPower:AVERage[:STATe]
[:SENSe]:SPURious:AVERage[:STATe]