Anritsu MS2830A - [:SENSe]:CHPower[:STATe] ON|OFF|1|0; :CALCulate:CHPower[:STATe] ON|OFF|1|0

Chapter 2 SCPI Device Message Details
2-480
[:SENSe]:CHPower[:STATe] ON|OFF|1|0
Measure Channel Power
Function
This command executes Channel Power measurement.
Command
[:SENSe]:CHPower[:STATe] <switch>
Parameter
<switch>
CHP measurement On/Off
ON|1
Sets CHP measurement to On.
OFF|0
Sets CHP measurement to Off (Default).
Example of Use
To set CHP measurement to On.
CHP ON
Related command
This command has the same function as the following command.
:CALCulate:CHPower[:STATe]
:CALCulate:CHPower[:STATe] ON|OFF|1|0
Measure Channel Power
Function
This command executes Channel Power measurement.
Refer to
[:SENSe]:CHPower[:STATe].
Related command
This command has the same function as the following command.
[:SENSe]:CHPower[:STATe]