Anritsu MS2830A - Page 1209

Chapter
４
Native Device Message Details
4-127
4
Native Device Message Details
When Standard is set to ISDB-T
SB
(Spectrum Emission Mask
measurement)
pattern
Parameter to set
3M9BW
3.9 MHz BW
When omitted 3.9 MHz BW
When Standard is set to ISDB-T (Channel Power measurement)
pattern
Parameter to set
MEAN_5M6BW
5.6 MHz BW
When omitted 5.6 MHz BW
When Standard is set to ISDB-T (OBW measurement)
pattern
Parameter to set
5M6BW
5.6 MHz BW
When omitted 5.6 MHz BW
When Standard is set to ISDB-T (Spectrum Emission Mask
measurement)
pattern
Parameter to set
5M6BW
5.6 MHz BW
When omitted 5.6 MHz BW
When Standard is set to WLAN (ACP measurement)
pattern
Parameter to set
T403_18MSPAN
TELEC T-403 5 GHz Low Power Data
Communication System Sweep Band 18 MHz
T403_19MSPAN
TELEC T-403 5 GHz Low Power Data
Communication System Sweep Band 19 MHz
T403_38MSPAN
TELEC T-403 5 GHz Low Power Data
Communication System Sweep Band 38 MHz
T403_78MSPAN
TELEC T-403 5 GHz Low Power Data
Communication System Sweep Band 78 MHz
T405_20MBW
TELEC T-405 5 GHz Wireless Access System 20
MHz System
T405_40MBW
TELEC T-405 5 GHz Wireless Access System 40
MHz System
When omitted TELEC T-403 5 GHz Low Power Data
Communication System Sweep Band 18 MHz
When Standard is set to WLAN (OBW measurement)
pattern
Parameter to set
T401_DCCK
TELEC T-401 2.4 GHz Enhanced Low Power
Data Communication System, Direct Sequence
Spread Spectrum System