Anritsu MS2830A - Page 1313

Chapter
４
Native Device Message Details
4-231
4
Native Device Message Details
Parameter
bandwidth_n
Integrate BW of Offset-n
Range 30 Hz to 20 MHz
Resolution Integrate BW is as below.
1 Hz (30 Hz to 1 kHz)
10 Hz (1 to 10 kHz)
100 Hz (10 to 100 kHz)
1 kHz (100 kHz to 1 MHz)
10 kHz (1 to 20 MHz)
Suffix code HZ,KHZ,KZ,MHZ,MZ,GHZ,GZ
Hz is used when omitted.
Details
The setting range of this function is limited depending on the setting of
RBW of the target offset. Refer to
MS2690A/MS2691A/MS2692A Signal
Analyzer Operation Manual(Spectrum Analyzer Function Operation)
or
MS2830A/MS2840A Signal Analyzer Operation Manual (Spectrum
Analyzer Function Operation)
for details.
This command is not available when Detection of the target offset is set
to the following:
•
Pos&Neg
•
Positive
•
Negative
•
Sample
Example of Use
To set Integrate BW of the offset.
SEM:OFFS:LIST:BAND:INT
3KHZ,3KHZ,3KHZ,10KHZ,10KHZ,10KHZ,3KHZ,3KHZ,3KHZ,10KHZ,10
KHZ,10KHZ
SEM:OFFS:LIST:BAND:INT?
>
3000,3000,3000,10000,10000,10000,3000,3000,3000,10000,10
000,10000