Anritsu MS2830A - Page 420

Chapter 2 SCPI Device Message Details
2-410
When Offset Setup Mode is Advanced
In ACP measurement (when ACP Result Type is OFFSet)
Two values of ref_carrier_a are output when ACP Reference is
BSIDes.
<ref_carrier_a>(,<ref_carrier_a>),
<lower_offset_1_rel>,<lower_offset_1_abs>,
<upper_offset_1_rel>,<upper_offset_1_abs>,
<lower_offset_2_rel>,<lower_offset_2_abs>,
<upper_offset_2_rel>,<upper_offset_2_abs>,
<lower_offset_3_rel>,<lower_offset_3_abs>,
<upper_offset_3_rel>,<upper_offset_3_abs>,
<lower_offset_4_rel>,<lower_offset_4_abs>,
<upper_offset_4_rel>,<upper_offset_4_abs>,
<lower_offset_5_rel>,<lower_offset_5_abs>,
<upper_offset_5_rel>,<upper_offset_5_abs>,
<lower_offset_6_rel>,<lower_offset_6_abs>,
<upper_offset_6_rel>,<upper_offset_6_abs>,
<lower_offset_7_rel>,<lower_offset_7_abs>,
<upper_offset_7_rel>,<upper_offset_7_abs>,
<lower_offset_8_rel>,<lower_offset_8_abs>,
<upper_offset_8_rel>,<upper_offset_8_abs>
(n=1 or when omitted)
In ACP measurement (when ACP Result Type is CARRier)
<integration_abs>,<total_carrier_a>,
<power_1>,<power_2>,<power_3>,<power_4>,
<power_5>,<power_6>,<power_7>,<power_8>,
<power_9>,<power_10>,<power_11>,<power_12>
(n=1 or when omitted)