Anritsu MS2830A - Page 897

2.17 Configuring Batch Measurement Settings
2-887
2
SCPI Device Message Details
Table 2.17-7 Parameter List Settings (SEM Measurement) (Cont
’
d)
Parameter Attribute Name Setting Attribute Value Setting
SEM Offset1 Fail Logic
“SEM Offset1 Fail Logic”
“
ABS1
”: ABS1
“REL”: REL
“
ABS1 and REL
”:
ABS1 and REL
“
ABS1 or REL
”:
ABS1 or REL
“
ABS1 and ABS2
”:
ABS1 and ABS2
“(
ABS1 and REL)
 and
ABS2
”:
(ABS1 and REL) and ABS2
“(
ABS1 or REL)
 and
ABS2
”:
(ABS1 or REL) and ABS2
“
Off
”: Off
SEM Offset2 Fail Logic
“SEM Offset2 Fail Logic”
Same as above
SEM Offset3 Fail Logic
“SEM Offset3 Fail Logic”
Same as above
SEM Offset4 Fail Logic
“SEM Offset4 Fail Logic”
Same as above
SEM Offset5 Fail Logic
“SEM Offset5 Fail Logic”
Same as above
SEM Offset6 Fail Logic
“SEM Offset6 Fail Logic”
Same as above
SEM Limit Side
“SEM Limit Side”
“
Both
”: Both
“
Upper
”: Upper
“
Lower
”: Lower
SEM Result Type
“SEM Result Type”
“
Peak
”: Peak
“
Margin
”: Margin