Only the most important (i.e. most frequently used) configuration parameters
are displayed here for each specified layer. To access all parameters, launch
the frame composition 'Stream Setup' dialog box accessible via the button in
the top left-hand part of the screen.
Composing the Ethernet frameComposing the Ethernet frame
The following headers/layers are available for the frame configuration:
You can use either a 'quick' mode or a 'detailed' mode to set up the selection
of headers/layers. Touching the button at the top of the setup area will launch
the
detailed mode
dialog box (the Stream Setup dialog box ). Touching the
arrow to the right of the button will open the
quick selection menu
.
The quick selection menu contains a number of predefined frame
configurations (e.g. ETH/VLAN/IPv4ETH/VLAN/IPv4). The detailed mode dialog box allows
you to specify the frame configuration yourself and also provides you with
access to all configuration parameters available for the individual layers.
The detailed mode (Stream SetupStream Setup) dialog box is described in detail below.
Follow another portFollow another port
It is possible to let the Port 2 copy the setup from Port 1 by touching the FollowFollow button.
When this button is displayed in green, Port 2 continues to follow Port 1 change. This
button appears when the Port 1 settings can be copy to Port 2.
MultistreamsMultistreams
When the Multistream is active, the screen contains a StreamStream slide-out, which
allows you to select the relevant stream to view/configure. The name of the
slide-out control indicates which stream is currently being displayed.
To Next Page
Loading...
