ZoomZoom
Select the contents corresponding to the test to display.
SyncSync: Displays the one way delay obtained by using the
Sync
message
timestamp. This is the delay in direction from DUT to Network Master.
Follow upFollow up: Displays the one way delay obtained by using the
Follow_Up
message timestamp. This is the delay in direction from DUT to Network
Master.
Delay req.Delay req.: Displays the one way delay obtained by using the
Delay_Response
message timestamp. This is the delay in direction from Network Master to
DUT.
Select SyncSync when Step mode is set to One-stepOne-step in SetupSetup tab of IEEE1588v2
screen. Select Follow upFollow up when Step mode is set to Two-stepTwo-step.
To zoom in, select a zoom area directly in the graph area by drawing a
rectangle with a finger or the stylus (delivered with the instrument).
When releasing the finger or stylus, the graph area zooms in to show the
selected part of the graph.
To zoom out, use the view settings below the graph.
View modeView mode
Used to set the x-scaling for the graph. The possible settings are:
Last 1000sLast 1000s, Last 100sLast 100s: Shows a sliding graph area with max. width of 1000
second and 1000 second.
View allView all: Shows a graph area with a width as the duration of the test.
CustomCustom: This is automatically selected when the graph area is touch-
manipulated.
Max vertical axisMax vertical axis
Used to set the y-scaling of the view. The maximum amplitude of the plot
always originates from the zero line.
In general, you use direct touch-manipulation of the graph area to zoom in and use the
controls to zoom out.
66..1313..33..44 Packet TEPacket TE
Touching the Packet TEPacket TE in the navigation area displays the screen shown
below.
To Next Page
Loading...
