Chapter 2 OPERATION PROCEDURES
23
2.3 Setting the names
When timing or pattern data is edited and the edited data is to be saved, the name used for the program can be
changed.
(1)
Select Name using or
INC
DEC
, and
then press
SET
.
To decide on the positions where the
character changes are to be made:
INC
(when moving to the left)
DEC
(when moving to the right)
The position where the character of the name is to be
input changes.
To delete all the characters:
R/Pr
All the characters already input for the name are
cleared.
To delete one character:
G/Y
The character at the cursor position is deleted.
To change character insert/overwrite:
B/Pb
Use this to switch between inserting and
overwriting the characters.
Insert is switched to overwrite or vice versa.
(2)
To input characters:
Select the characters using , and enter
them using
SET
.
The characters are input.
(3) To enter the program name:
Select OK using
SET
.
The name is changed.
To Next Page
Loading...
Need help?
General
