ASTRO VG Series User Manual

Chapter 4 INTERFACE SETTINGS
177
4.10 VGA (D-Sub)
4.10.1 Connectors and pin assignments
Pin no. Signal Pin no. Signal
1 R 9 +5 V (DDC power supply *1)
2 G 10 GND
3 B 11 GND
4 NC 12 DDC DATA
5 NC 13 HS
6 GND (R) 14 VS
7 GND (G) 15 DDC CLK
8 GND (B)
*1: Restrictions apply to the supply current of the DDC power supply. Refer to “12.3 Concerning the
maximum current consumption of the DDC (DP_PWR) power supply.”
4.10.2 Video level settings
The setting procedure is the same as for the analog component signals.
Refer to “4.1.7 Setting the analog level” and “4.7.2 Setting the analog output connectors.”
4.10.3 Sync signal settings
The setting procedure is the same as for the analog component signals. Refer to “4.1.2 Setting the sync
signals to ON or OFF and setting the sync signal polarities”
4.10.4 EDID
The operation procedure is the same as for HDMI. Refer to “6.13.3 EDID.”
4.10.5 DDC/CI
The operation procedure is the same as for DVI. Refer to “6.13.4 DDC/CI.”
10
5 1
6
15 11

ASTRO VG Series Specifications

General

Brand	ASTRO
Model	VG Series
Category	Portable Generator
Language	English