402
8.2 HDCP execution
8.2.1 Execution procedure
One of the following three steps can be taken for HDCP execution.
a) Set enable or disable using the On/Off customize key.
b) Set enable or disable using Configuration.
c) Set enable or disable for each program.
a) Setting enable or disable using the On/Off customize key
This setting is canceled when the program is changed, and b) Setting enable or disable always using
Configuration and c) Setting enable or disable for each program take effect.
(1)
Ⅰ. H DCP
HDCP is executed, and the authentication results screen
appears above the test pattern.
b) Setting enable or disable using Configuration
(1)
Select Configuration using
MENU
or
INC
DEC
, and then press
SET
.
(2)
Select HDCP using
or
INC
DEC
, and
then press
SET
.
The HDCP execution mode is set here.
0
Disable
HDCP execution is disabled.
1
Enable
HDCP execution is enabled.
(3)
Select Execute Mode using
or
INC
DEC
, and then press
SET
.
2
Program
HDCP execution enable/disable is set
for each program.
To Next Page
Loading...
Need help?
General
