ASTRO VG Series User Manual

412
9.1.4 LAN settings
These settings are performed when connection to the terminal is to be established from the LAN port.
(1)
Select Configuration using
MENU
or
INC
DEC
, and then press
SET
.
(2)
Select General using
or
INC
DEC
,
and then press
SET
.
(3)
Select LAN using
or
INC
DEC
, and
then press
SET
.
The IP is set here.
xxx.xxx.xxx.xxx Set the IP address.
The factory setting is 192.168.0.2.
The SUBNETMASK is set here.
xxx.xxx.xxx.xxx Set the subnetmask address.
The factory setting is 255. 255. 255.0.
The GATEWAY is set here.
xxx.xxx.xxx.xxx Set the gateway address.
The factory setting is 192. 168. 122.1.
The Port No. is set here.
(4)
<Inputting the parameters>
Select the parameters using
or
INC
DEC
, and then press
SET
.
Alternatively:
Select the parameters using the number keys
(
0/STATUS
to
9/F
), and then press
SET
.
xxxx
Set the number of the port to be used
by the terminal commands.
The factory setting is 8000.
CAUTION
 When you change setting here, please re-boot VG unit. The setting change is activated
after re-booting.

ASTRO VG Series Specifications

General

Brand	ASTRO
Model	VG Series
Category	Portable Generator
Language	English