Chapter 4 INTERFACE SETTINGS
51
4.1.7 Setting the analog level
In this section, the video level of the analog component signals is set.
The video signal gray scale remains unchanged, and only the level is changed.
There are two ways to set the analog input level: One uses the LEVEL key screen, and the other is from Program
Edit.
<How to set the analog input level on the LEVEL key screen>
(1)
Set the analog video level using
LEVEL
3
.
Change the analog level using or
INC
DEC
.
(2)
<When increasing the setting speed>
Change the analog level (more quickly) using
SHIFT
+ or
SHIFT
+
INC
DEC
.
Setting range:
When Video-on-Sync is not superimposed
0.05 V - 1.2 V
When Video-on-Sync is superimposed
0.30 V - 1.2 V
For the Video-on-Sync setting, refer to “4.1.2 Setting the
sync signals to ON or OFF and setting the sync signal
polarities.”
(3)
Select
LEVEL
or
ESC
Display returns to the initial screen.
<How to set the analog input level from Program Edit>
Refer to section “4.7.2 Setting the analog output connectors” (Video parameters).
They take effect only with the component output signals of the PC analog unit.
CAUTION
To Next Page
Loading...
Need help?
General
