ASTRO VG Series User Manual

26
2.5 Automatic execution
The data in the selected groups and program numbers can be automatically output in accordance with the delay time
which has been set.
(1)
MENU
(2)
Select Auto Edit using
or
INC
DEC
,
and then press
SET
.
(3)
Selecting the Mode setting
Select Program or Group using or
0/STATUS
1
.
(4)
Select Setting using
or
INC
DEC
,
and then press
SET
.
<When Program has been selected as the Mode
setting>
Interval:
The time during which each pattern is to be displayed is set
here from 0 to 999 seconds.
Program (Start-Stop):
The start and end points of programs to be repeated are set
here.
The start and end point settings can be designated in three
stages.
Automatic execution is performed in the following
sequence: Start point 1 → end point 1 → start point 2 →
end point 2 → start point 3 → end point 3.
<When Group has been selected as the Mode setting>
Group No.:
The number of the group to be executed automatically is
set here.
Interval
The time during which each pattern is to be displayed is set
here from 0 to 999 seconds.
When 0 is set, execution accords with the group data
setting. If the interval is not set in the group data, 0 seconds
will be set.
(5) For automatic execution, select EXECUTE using
or
INC
DEC
, and then press
SET
.
To cancel automatic execution at any time, press
ESC
.

ASTRO VG Series Specifications

General

Brand	ASTRO
Model	VG Series
Category	Portable Generator
Language	English