Bosch Rexroth ActiveMover - Page 150

150/188 Maintenance and repair
Bosch Rexroth AG, MIT: ActiveMover, 3 842 564 874/2021-04
Fig. 108:
557 186-97
7
SW3
4x
5
6
8
M
D
=2 Nm
PH2
Replacing the printed circuit board (gateway) (curve module)
5. Unplug the network
cable (1 and 2)
6. Loosen the ground
cable.
7. Loosen the 4 fi xing
screws and remove
the printed circuit
board (gateway).
Do not remove the
screws completely!
8. Check that there are
3 plastic discs on all 4
fi xing screws of the new
printed circuit board
(gateway).
 Install the new printed
circuit board (gateway)
in reverse order.