About this product 33/188
3 842 564 874/2021-04, MIT: ActiveMover, Bosch Rexroth AG
5.2.9 Workpiece pallet 3 842 559 433 (2 magnets)/3 842 559 434 (3 magnets)
NOTICE
Behavior in case of accidents with permanent magnets
For all works with permanent magnets, the following emergency tool must
be available in case of an accident to release trapped parts of the body
(e.g. fi nger, hand, arm, etc.):
• Hammer made of non-magnetic material (e.g. brass).
• At least two wedges with angles of approx. 10 - 15° made of non-magnetic
material such as brass, hard wood or the like for driving into the separating gap.
In case of an accident:
Keep calm.
If voltage is present, de-energize the machine immediately (emergency off switch).
Administer FIRST AID or request appropriate help (e.g. an emergency doctor).
Separate any adhering parts using the emergency tool so any trapped body
parts (e.g. fi nger, hand, foot etc.) can be freed.
To do this, drive the wedges into the separating gap using the hammer so that
the trapped body parts can be freed.
General safety instructions for magnets
Magnetic and electromagnetic fi elds are generated in the direct vicinity of live
conductors or permanent magnets of electric motors and may constitute a serious
danger for certain groups of persons.
Machine operators must be suffi ciently protected from any damage that might
occur in these areas by means of suitable measures (e.g. warnings, protective
equipment, marking of hazard areas).
Observe the following safety instructions specifi ed in the assembly instructions.
Observe the relevant regulations valid in the specifi c country. For Germany,
the specifi cations of the German trade association with respect to
"Electromagnetic fi elds" in BGV B11 and BGR B11 must be observed.
To Next Page
Loading...
