Bosch Rexroth ActiveMover - Connecting Network - Printed Circuit Boards (Gateway)

Installation 99/188
3 842 564 874/2021-04, MIT: ActiveMover, Bosch Rexroth AG
7.6.10 Connecting network - printed circuit boards (gateway)
NOTICE
Malfunctions due to incorrect assembly and commissioning
The product can get damaged, shortening its service life.
 Network cables must not cross
Fig. 73:
6
5
4
1
2
3
LKJ
DC
P
EBA F G H I
O
M
N
557 186-67
1
2
3
b/a
Adress 2
Right Network
6
5
4
b/a
Adress 1
Right Network
b/a
Adress 3
Right Network
b/a
Adress 5
Left Network
b/a
Adress 4
Left Network
b/a
Adress 6
Left Network
Connecting printed circuit boards (gateway)
Please note:
• The two networks Right
Network and Left Network
must not be connected
to the respective network
ends A and C!
• Guide the network
cable for connecting
the printed circuit boards
(gateway) through the
duct connections with
the cable glands of the
section/curve modules.
 Connect the printed
circuit boards (gateway)
in accordance with the
adjacent connection
plan.
See next page for
explanations of the
positions.