54/188 Installation
Bosch Rexroth AG, MIT: ActiveMover, 3 842 564 874/2021-04
7.5.2 Customer base frames
Customer base frames must be dimensioned and designed according to the
loads to be expected. They must be prepared with the required installation bores
according to the dimensional drawing. The dimensional drawing can be found in the
ActiveMover sales catalog.
Assembly of the section/curve modules is carried out in the same way as described
in chapters 7.5.4 to 7.5.13.
7.5.3 Assembly without fi xing plates on customer base frames
Section/curve modules can generally also be assembled without fi xing plates.
Interface between section/curve modules and the base frame are the corresponding
bores on the fi xing plates. These must be inserted into the base frame.
Dimensional drawings for this can be found in the ActiveMover sales catalog.
Assembly of the section/curve modules is carried out in the same way as described
in chapters 7.5.4 to 7.5.13.
To Next Page
Loading...
