Bosch Rexroth ActiveMover - Assembling the Section Module on a Base Frame

Installation 57/188
3 842 564 874/2021-04, MIT: ActiveMover, Bosch Rexroth AG
7.5.5 Assembling the section module on a base frame
Fig. 33:
1
2
557 186-32
2 x Ø12
10
2 x
ISO8375 –
16 x 40 – A – ST
2 x
ISO8375 –
12 x 40 – A – ST
!
2 x
3842559454
Assembling the fi xing plates (1)
Please note:
The assembly must be
carried out on an already
aligned base frame at
the fi nal position of use
(see fi g. 31 on page 55).
1. Position the fi xing plates
3 842 559 454 (2x)
above the mounting
holes in the base frame.
2. Hammer down the
cylinder pins into the
holes of the base frame
through the positioning
holes of the fi xing plates.