14/188 Safety instructions
Bosch Rexroth AG, MIT: ActiveMover, 3 842 564 874/2021-04
• An idle system is not necessarily a safe system, as stored energy can be released
unintentionally or through improper maintenance procedures.
• After an EMERGENCY STOP or a malfunction, only switch the system back on once
you have established and rectifi ed the cause of the fault.
• Make sure that access to maintenance and inspection points is kept unobstructed.
• Perform the prescribed maintenance work at the intervals specifi ed in chapter 10.3
"Maintenance".
• Make sure that no line connectors, connections or components are disconnected
as long as the system is supplied with pressure and voltage. Secure the system
against being switched back on.
• Dispose of the product in accordance with the regulations in your country.
2.7 Personal protective equipment
• Appropriate protective clothing should be worn when handling/using the product
(e.g. safety shoes, safety goggles, safety gloves, close-fi tting clothing, a hair net for
long, loose hair).
As the system user or operator, you are personally responsible for ensuring the use
of appropriate protective equipment when the product is being used.
All component parts of the personal protective equipment must be free of damage.
2.8 Owner responsibilities
• Before the initial commissioning or re-commissioning of a conveyor system,
carry out a risk assessment in accordance with DIN EN ISO 12100.
• Before initial commissioning, make sure there are no protruding or sharp-edged
parts that may be a hazard to personnel working or moving in the area.
• Provide safety-related instructions to the operating personnel before initial
commissioning or re-commissioning, and then at regular intervals.
EMERGENCY STOP,
malfunction
During servicing and repair
During disposal
To Next Page
Loading...
