Safety instructions 13/188
3 842 564 874/2021-04, MIT: ActiveMover, Bosch Rexroth AG
• Do not attempt to modify the product.
• Do not expose the product to any mechanical loads under any circumstances.
Never use the product as a handhold or step. Do not place any objects on the
product.
• Always ensure that the product cannot topple over.
• Observe the transport instructions on the packaging.
• Inspect the product for obvious transport damage.
• Lay cables and lines so that they cannot be damaged and no one can trip over
them.
• Make sure the system component you are working on is depressurized and
de-energized before assembling the product or inserting or removing plugs.
• Ensure that the system component cannot be switched back on.
• Before commissioning, make sure that all seals and plugs for the screwed
connections are correctly installed and undamaged to prevent liquids and foreign
bodies from entering the product.
• Follow the fi ve safety rules:
– De-energize.
– Secure against reactivation.
– Ensure absence of voltage on all poles.
– Ground and short-circuit.
– Cover or block off any adjacent live parts.
• Allow the product to acclimatize for a few hours prior to commissioning in order to
prevent water condensation from forming in the housing.
• Make sure that all electrical connections are either being used or are covered.
• Check the safety requirements according to DIN EN 619.
• Only start up a product that has been completely installed.
• Make sure that all the safety equipment which forms part of the product is present,
has been properly installed, and is fully functional. Do not move, bypass or disable
any safety equipment.
• Do not reach into moving parts.
• Check the product for malfunctions.
• Make sure that only authorized personnel perform the following tasks within the
scope of the product’s intended use:
– Starting or operating the system, or interfering with its normal operation.
– Operating component or part adjusters.
• Only allow people to be in the immediate vicinity of the product when it is
operating if they are authorized by the owner to be there. This also applies when
the product is idle.
• Make sure that:
– There are no obstacles preventing access to the EMERGENCY STOP controls.
– All delivery points, workstations and passages are kept clear.
• Do not use EMERGENCY STOP controls for routine stopping or the operational
switch-off.
• Regularly check the EMERGENCY STOP controls to ensure that they are functioning
properly.
• Following an EMERGENCY STOP or in the event of a fault or other irregularity,
turn the product off and secure it against being switched back on.
• Do not reach into moving parts.
General
During transport
During assembly
When working on the
electrical system
During commissioning
During operation
To Next Page
Loading...
