178/188 Troubleshooting
Bosch Rexroth AG, MIT: ActiveMover, 3 842 564 874/2021-04
11.2 Communication error
Errors Remedy
The confi guration
software cannot establish
a connection to the
controller (e.g. ActiveMover
in service mode)
• Try to access diagnostic information via the following website:
http://controller_IP_address/sdm
The IP address of the controller is required for this procedure.
• Check the controller LEDs (see chapter 11.4 Diagnostic LEDs
on page 179).
11.3 Operating mode error
Errors Remedy
Service mode Reset controller does not work.
Switch off main switch, wait 5 s and switch on the main switch
again. Reboot ActiveMover controller and check whether controller
starts in RUN mode.
If the error is not remedied, repeat the process max. 4 - 5x, then
contact Bosch Rexroth Service.
To Next Page
Loading...
