Bosch Rexroth ActiveMover - Replacing the Drive Thermistors

Maintenance and repair 151/188
3 842 564 874/2021-04, MIT: ActiveMover, Bosch Rexroth AG
10.4.20 Replacing the drive thermistors
Fig. 109:
557 186-100
1
1
5x
SW4
10x
1
M
D
=10 Nm
4
2
3
4
2
4
4
3
Replacing the drive thermistor
Necessary spare parts
• Drive thermistor
3 842 555 971
1. Open the protective fl ap
of the electronics box
of the section module
or disassemble the
protective cover of the
curve module.
2. Unplug the thermistor
cable plug-in connection
from the printed circuit
board of the power
supply.
3. Remove the thermistor
from the thermistor
mounting.
4. Install the new thermistor
in reverse order.
Please note:
The thermistor must be
pushed all the way into the
thermistor mounting.