Bosch Rexroth ActiveMover - Page 53

Installation 53/188
3 842 564 874/2021-04, MIT: ActiveMover, Bosch Rexroth AG
Overall systems with a length < 10 m
 Start assembling a system section with section module  on the left or right of
a system section with curve module.
For detailed description of assembly, see chapter 7.5.4 to 7.5.13.
 In the following, these system sections with section module are referred to as
reference system sections.
Fig. 30:
557 186-29
213453
Assembly sequence for overall system length< 10 m
 Then install additional attaching system sections.
 Align all other assembled system sections vertically, horizontally and vertically in
accordance with the reference system section.
Final tests and settings
 Check the module distance of 0.5 mm.
 Check the suitability of the linear motors lamination between the section/curve
modules.
 Assemble the profi le connectors on the rear side at the connection point between
the section/curve modules.
 Adjust the transition of the upper V-rails using the profi le connector.
 Check the transition between the section/curve modules using a workpiece pallet.