EasyManuals Logo

Bosch rexroth KMS03.1B-A036-P-D7-ET-END-L3-TO-FW User Manual

Bosch rexroth KMS03.1B-A036-P-D7-ET-END-L3-TO-FW
422 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #291 background imageLoading...
Page #291 background image
9 Mounting and installation
9.1 Introduction
9.1.1 Important notes
Safety
Injuries caused by live parts! Lifting of heavy
loads!
WARNING
Install the motors only when they have been de-energized and are not
connected electrically.
Use suitable lifting gear, protective equipment and protective clothing during
transport.
Observe the safety instructions contained in the preceding chapters.
Carry out all working steps with particular care. In this way, you minimize the
risk of accidents and damages.
Qualified technical staff
Any work at the installation and the drives or in their vicinity may be carried
out only by appropriately trained technical staff.
Make sure that all persons carrying out installation work, maintenance work
or operational activities at the installation are adequately familiar with the
contents of this documentation, as well as with all warnings and
precautionary measures contained therein.
Qualified technical staff must be trained, instructed and qualified to switch
electrical circuits and devices on and off in accordance with technical safety
regulations, to ground them and to mark them. Qualified technical staff must
possess appropriate safety equipment and have been trained in first aid.
Handling the devices
Injuries or damage and invalidation of the
warranty due to improper handling!
CAUTION
Avoid mechanical stressing, throwing, tipping or dropping of the products.
Use only suitable lifting gear.
Use suitable protective equipment and protective clothing during transport.
Wear safety shoes.
Protect the products against dampness and corrosion.
At delivery, the output shafts have protective sleeves and the connection
points have covers. During transport and storage, the protective sleeves and
covers must be attached to the device.
Remove the protective sleeves just before mounting.
Also use the protective sleeves if you return the goods.
IndraDrive Mi Drive Systems with KCU02, KSM02,
KMS02/03, KMV03, KNK03, KLC03
277/407
Mounting and installation
R911335703_Edition 04 Bosch Rexroth AG

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Bosch rexroth KMS03.1B-A036-P-D7-ET-END-L3-TO-FW and is the answer not in the manual?

Bosch rexroth KMS03.1B-A036-P-D7-ET-END-L3-TO-FW Specifications

General IconGeneral
BrandBosch
Modelrexroth KMS03.1B-A036-P-D7-ET-END-L3-TO-FW
CategoryDC Drives
LanguageEnglish

Related product manuals