3.4 Explanation of signal words and the Safety alert symbol
The Safety Instructions in the available application documentation contain
specific signal words (DANGER, WARNING, CAUTION or NOTICE) and,
where required, a safety alert symbol (in accordance with ANSI
Z535.6-2011).
The signal word is meant to draw the reader's attention to the safety
instruction and identifies the hazard severity.
The safety alert symbol (a triangle with an exclamation point), which
precedes the signal words DANGER, WARNING and CAUTION, is used to
alert the reader to personal injury hazards.
In case of non-compliance with this safety instruction, death or serious injury
will occur.
In case of non-compliance with this safety instruction, death or serious injury
could occur.
In case of non-compliance with this safety instruction, minor or moderate
injury could occur.
In case of non-compliance with this safety instruction, property damage could
occur.
44/407
Safety instructions for electric drives and controls
IndraDrive Mi Drive Systems with KCU02, KSM02,
KMS02/03, KMV03, KNK03, KLC03
Bosch Rexroth AG R911335703_Edition 04
To Next Page
Loading...
Need help?
General