BST ekrPro Com60 - Page 156

Default settings D 2
ekrPro Com
60
web guide controller EDV-No.: MD.191.01.05/1.6.x Chapter: D2
with analog sensors Date: 23.11.2007 Page: 5/6
Menu Parameter Level 1 Parameter Level 2 Parameter Level 3 Default Value
Params 1 off
off
0
0
0
0
Params 2 off
off
0
0
0
Opt. Logic
0
Status Bus type unknown
Module status 0
Data exchange not running
Last interrupt 0
Profibus Address 3
Swap Bytes off
Swap Words off
DeviceNet Address 3
Baudrate 500 kbps
Swap Bytes off
Swap Words off
CANopen NMT Master
One fieldbus
device only!
active
Bus off off
No Sync
off
Sync Time [µs]
One fieldbus
device only!
4000
Fieldbus
Node Id 11
Remote Device
Select remote device This device
Sensor 1 Dark -2048
Bright +2047
Sensor 2 Dark -2048
Bright +2047
Sensor 3 Dark -2048
Bright +2047
Man. Man. setup –
sensor 3
Offset 0
Material Setup
Gain 1.00