BST ekrPro Com60 - Page 155

Default settings D 2
ekrPro Com
60
web guide controller EDV-No.: MD.191.01.05/1.6.x Chapter: D2
with analog sensors Date: 23.11.2007 Page: 4/6
Menu Parameter Level 1 Parameter Level 2 Parameter Level 3 Default Value
Tear Off Det. Edge 1 Sensor none
Threshold [%] 80/20
Sign. chg. limit
[%/4ms]
10
Delay time [ms] 20
Hold time [ms] 1
Edge 2 Sensor none
Threshold [%] 80/20
Sign. chg. limit
[%/4ms]
10
Delay time [ms] 20
Hold time [ms] 1
Edge 3 Sensor Edge 3
Threshold [%] 80/20
Sign. chg. limit
[%/4ms]
10
Delay time [ms] 20
Hold time [ms] 1
Center 1&2 Sensor none
Threshold [%] 80/20
Sign. chg. limit
[%/4ms]
10
Delay time [ms] 20
Hold time [ms] 1
Oscillation mode Osc. Opmode off
Osc. Params. Amplit. Auto [%] 40
Amplit. SC [%] 4
Amplit. FVG 10.0
Add. Functions
Frequency [Hz] 0.50
Configure
Configure Digital I/O [Press ‚set’] Gig.IN Table 1
Dig. Inputs enabled
yes
Dig. Outputs enabled yes
Inputs
See chapter B3.7.5.9.2
Dig. IO Config.
Outputs
See chapter B3.7.5.9.4
Change Password User Level Admin.
Password 0
(displayed)
Timeout [min] 0
Dev. Config Backlight Time 0
(permanent on)
Show errors active
Confirm errors off
SW Version -
Special
Low V cnt. 0