F6000 Family of Power System Simulators User Guide
72A-1589 Rev. C 02/01 7-11
D
DD
D
R
RR
R
A
AA
A
F
FF
F
T
TT
T
3
33
3
/
//
/
5
55
5
/
//
/0
00
0
1
11
1
To install a new front panel, reverse the above steps as follows:
1. Lay the new front panel face down in front of the instrument, with the
communications board on the right.
2. Reconnect the ground wire in front of the circuit breaker.
3. Reconnect the blue and brown AC leads to the circuit breaker.
• Connect the blue lead opposite the blue wire at the front of the
circuit breaker.
• Connect the brown lead opposite the brown wire at the front of
the circuit breaker.
4. Reconnect wire W8 to the Output Terminal board.
5. Tilt the front panel up and rest the bottom of the front panel inside the
bottom of the black instrument frame.
6. Line up the connector at the bottom of the High Current Interface
board with its mate on the motherboard.
7. Tilt the front panel into a vertical position and press the bottom of the
panel until the High Current Interface connector mates.
8. Secure the front panel with 12 hex-head screws.
9. Reconnect W2, W3, W4, W5, W6, and W7 (see Table 7.2 on
page 7-12).
10. Replace the instrument cover.
To Next Page
Loading...
