doble F6000 - Setting F6000 IP Address

Set the F6000 IP Address
B-8 72A-1589 Rev. C 02/01
D
DD
D
R
RR
R
A
AA
A
F
FF
F
T
TT
T
3
33
3
/
//
/
5
55
5
/
//
/0
00
0
1
11
1
Set the F6000 IP Address
The Set IP Address utility sets or changes the IP address that the
instrument uses for Ethernet communications. The current IP address of
the instrument, if assigned, appears in the display on the instrument front
panel after a successful boot-up.
To set the instrument IP address:
1. Click Tools|F6000 IP Set in the ProTesT menu bar.
The Set F6000 IP Address dialog box appears (Figure B.8).
Figure B.8 Set F6000 IP Address
2. Enter the IP Address in the IP Address field.
3. Click Set.
4. Click Get to obtain the IP Mask that corresponds to the IP Address
entered in step 3.
The mask name appears in the IP Mask field.
If necessary, click Change to enter new communications parameters.
Refer to ”Communications Parameters” on page A-3.