doble F6000 - Pre-set Configuration Options

Pre-set Configurations
3-10 72A-1589 Rev. C 02/01
D
DD
D
R
RR
R
A
AA
A
F
FF
F
T
TT
T
3
33
3
/
//
/
5
55
5
/
//
/0
00
0
1
11
1
Pre-set Configurations
To use a pre-set configuration, select one of the options from the pick list
at the bottom of the display:
• User Defined
• 3 Voltages and 3 Currents
• 3 Voltages and 3 Transient Currents
• 4 Voltages and 4 Currents
• 6 Currents (right bank)
• 1 Voltage and 2 Low Range Currents
• 1 Voltage 150 VA and 1 Current 450 VA
• 4 Voltages and 4 Transient Currents
• 6 Voltages
• 6 Low Range Currents
• 6 Low Range Transients
• 6 Transient Currents
• 1 Voltage and 2 Low Range Transients
To finish configuring the sources, click one of the three buttons at the
bottom of the display (Figure 3.5 on page 3-8):
• Click OK to configure the sources on the F6000 Instrument and
close the F6000 Configuration display.
• Click Cancel to ignore changes to the source configuration and
close the F6000 Configuration display.
• Click Apply to configure the sources on the F6000 Instrument
without closing the F6000 Configuration display.